Foxcom Platino de banda Ancha PL7442T/PL7442R4 RF Enlace Amplia Gama de potencias, 4dB Presupuesto Óptico de 8 km - 1310 nm o 15Km - 1550nm

Foxcom Platinum Wideband PL7442T/PL7442R4 RF Link de amplio rango de potencia, 4dB de presupuesto óptico 8Km - 1310nm o 15Km - 1550nm

IKtechcorp es el distribuidor de Foxcom Communications Fiber Optic Systems, un fabricante y proveedor líder de equipos satelitales comerciales. Foxcom ofrece una amplia gama de enlaces de fibra utilizados en las industrias VSAT, DTH, COTM, Teleport, Cable y Broadcast. Satélite, DTH, VSAT, óptica, fibra óptica, RF

• Banda ancha: 10–3000 MHz
• Más de 8 km. distancia [15Km con el PL7442T1550]
• Potentes capacidades de administración a través de una pantalla LCD en el panel frontal y SNMP montado en rack
• Control del usuario y configuración del nivel de IMD requerido
• Variedad de conectores ópticos y de RF

Código: foxcom_PL7442R4

Llamar para preguntar el precio

Foxcom Platinum Wideband PL7442T/PL7442R4 RF Link Wide Power Range, 4dB Optical Budget 8Km - 1310nm or 15Km - 1550nm



Summary
Foxcom Platinum Wideband PL7442T/PL7442R4 RF Link Wide Power Range, 4dB Optical Budget 8Km - 1310nm or 15Km - 1550nm Foxcom’s Platinum Wideband products are designed to meet the increasing demand for modularity and high-performance in a small form factor for superior long-distance transmission. With high RF input power and wide dynamic range, the link is designed to provide full specification service up to a full 4 dB optical budget with thePL7440R4 receiver. Utilizing Foxcom’s DigiRF technology, the user has full control of all important functions for setup, operation, and analysis via the front panel LCD or via the associated subrack SNMP capability. In addition IMizer, an automated adjustable link calibration embedded system enables the user to align the RF links IMD/CNR to specific linearity performances without a two-tone test. Select the desired IMD for the optical transmitter, either locally or remotely, IMizer automatically adjusts the laser drive to meet the IMD requirements. TheIMizer requires the use of a correction factor table above 2.5 GHz. Each low profile individual transmitter or receiver can be “hot swapped” in the subrack chassis maintaining a best subsystem uptime capability. Each module contains an individual processor to maximize specification performance at all times under demanding user applications. The PL7440T transmitter and PL7440R4 receiver are designed for subrack chassis mounting. The associated Platinum chassis, model PL7010, has 12 active slots, one main control processor (MCP) slot and two redundant power supplies. No fans are required even under full subrack loading and full LNB powering.

Order Diagram - Options

Foxcom Platinum Wideband PL7442T / PL7442R4 RF Link Wide Power Range, 4dB Optical Budget 8Km - 1310nm or 15Km - 1550nm

RF Specifications	Units	Typical	Minimum	Maximum

Frequency Range - Bandwidth	MHz	10 - 3000		3000
Amplitude Response @ Unity Gain 10 - 3000 MHz any 36 MHz	dB	±2 ±0.25		±2.25 ±0.3
Gain Stability	dB/24hr	± 0.2		± 0.25
Gain Slope1	dB	0	-1.5	+1.5
Gain Variation over temperature	dB	± 1.5	-2	2
SFDR2	dB/Hz2/3	104
SFDR3	dB/Hz2/3	105
DR (Dynamic Range - single channel)4	dB			50
CNR [1Hz]2	dB	133	130	135
Noise Figure (NF)2	dB	37	42	35
Noise Figure (NF)3	dB	16	19	14
Output IP3 (OIP3)5	dBm	20
Group Delay Variation- linear 10 to 60 MHz 60 - 3000 MHz	ns	13 1.5		-15 -11
Input/Output Impedance	Ohm	50 or 75
1 dB Compression Point	dBm	2		3
Phase Noise6	dBm	None
Third Order InterModulation [IMD]4	dBc		-55	-40
Input Signal Range - Total Power7	dBm		-50	0
Maximum Input without Damage	dBm			+15
RF Output Signal Range - Total Power 8 9	dBm		-40 -40	+5 +5
TX/RX Input/Output Return Loss 50 Ohm 75 Ohm 13	dB	-15 -13		-15 -11
Test Port [front panel sample port]10	dB	-20	-22	-18
RF Connector Type Input/Output Test Port		SMA, N BNC


Optical Specifications		Typical	Minimum	Maximum

Optical Wavelength	nm	1310/1550/CWDM
Optical Power Output	mW / dBm	2 / 3	1.7/2.5
Optical Budget / Distance 4 dB optical budget	dBm/Km	1310 nm \| 1550 nm 8 \|15
RX Optical Input Power	dBm	-1	-2	4
Optical Connector Types	Type	FC/APC or SC/APC (E2000 option)	-
Optical Return Loss	dB		-60	-55
Electrical Specifications
Supply Voltage	Vdc	12
Supply Current [TX]11	Amps	0.5
Supply Current (RX)	Amps	0.45
EMI Rating		EMI Rating: FCC Class B CE Mark

Physical Specifications


Operating Temperature Range	ºC		-10	+55
Storage Temperature Range	ºC		-45	+85
Relative Humidity		95% non-condensing
Altitude	ft / Km	10,000 [3.08 ] operating12 14,000 [12.2] non-operating
Dimensions [D×W×H]	ins/cm	12×0.8×4 / 30.5×2×10.2
Weight	lbs./Kg	0.5 / 0.23
MTBF	Hours	TX: 309, 481 RX: 359, 057
MTTR	Hours	0.083
Shock & Vibration		Designed for normal transportation environment per section 514.4 MIL-STD-810E. Designed to withstand 20G at 11 ms [½ sine pulse] in non-operating configuration.

Foxcom Platinum Wideband PL7442T / PL7442R4 RF Link Datasheet (104.87KB)